I wish to setup a central egress node that relays all traffic bound to the internet and later add custom DNS services like adguard to the mix. Created a new network, entered the suggested prefixes for a catch-all egress gateway and generated a new client for that network. However, when scanning the QR code on the device, Wireguard is unable to process the QR code and sometimes throws me an error 'unknown section in config'. https://docs.netmaker.org/egress-gateway.html (section NAT Gateway) My process: Nodes > select network > create egress gateway > enter egress gateway ranges as shown on the page above > enter wlan0 as interface ext.clients > select network > add external client > scan qr code Is the list of networks too long? Any suggestions to make this work?